Need help?Do you have a question about the Thermal Arc 400GTS CC/TIG and is the answer not in the manual?
General| Brand | Thermal Arc |
|---|---|
| Model | 400GTS CC/TIG |
| Category | Welding System |
| Language | English |
Explains the usage of NOTE, CAUTION, and WARNING labels in the manual.
Details health risks and precautions related to welding gases and fumes.
Covers critical safety measures for electric shock risks.
Covers critical safety measures for fire and explosion risks.
Outlines necessary precautions to protect hearing from loud noise.
Details precautions to protect eyes and skin from plasma arc rays.
Provides an overview of the Thermal Arc™ Model 400GTS welding power source.
Details safe procedures for moving and handling the welding equipment.
Covers requirements and precautions for connecting the welder to electrical power.
Lists key technical data and performance parameters of the 400GTS model.
Explains the concept of duty cycle and its calculation for welding power sources.
Details the various controls and indicators on the front panel of the welder.
Describes the switches and connections located on the rear panel of the welder.
Explains the function and characteristics of the Arc Control for SMAW mode.
Provides step-by-step instructions for setting up the welder for SMAW.
Details the setup process for Gas Tungsten Arc Welding using HF or Lift Start.
Guides the user through setting up GTAW for Pulsed, Sloped, and Spot welding modes.
Lists common faults that occur during welding operations, categorized by issue.
Provides a guide to identify and diagnose specific welding equipment problems.
Addresses troubleshooting steps for units with no weld output or inoperative states.
Covers troubleshooting for the warning indicator and input voltage related problems.
Details causes and remedies for erratic or improper weld output.
Troubleshoots issues like wandering arc and difficulty establishing high frequency.
Addresses problems with the power indicator, fan operation, and remote controls.
Explains the function and pinout of the 8-pin receptacle for remote controls.
Provides wiring diagram for 230/460V models of the 400GTS welder.
Provides wiring diagram for 380V models of the 400GTS welder.
Provides wiring diagram for 460/575V models of the 400GTS welder.
To Next Page