This manual is published for informational purposes only and the information so provided should not be considered as all-inclusive
or covering all contingencies. If further information is required Thermo King Corporation should be consulted.
Sale of product shown in this manual is subject to Thermo King's terms and conditions including, but not limited to, the THERMO
KING LIMITED EXPRESS WARRANTY. Such terms and conditions are available upon request.
Thermo King's warranty will not apply to any equipment which has been "so repaired or altered outside the manufacturers plants as,
in the manufacturers judgment, to effect it's stability".
No warranties, express or implied, including warranties of fitness for a particular purpose or merchantability, or warranties arising
from course of dealing or usage of trade, are made regarding the information, recommendations and descriptions contained herein.
Manufacturer is not responsible and will not be held liable in contract or in tort (including negligence) for any special, indirect or
consequential damages, including injury or damage caused to vehicles, contents or persons, by reason of the installation of any
Thermo King product or its mechanical failure.
Release History
(04-2005) Original
(08-2006) Add software revision 273 XX, V-400 MAX 30/50, V-500 MAX 20 1PH, V-500 MAX TC
10/20/30/50 1PH/3PH
(12-2006) Add software revision 273 XX, B-100 10/20
(03-2007) Add V-500 AC 10/20
(12-2007) To replace CB1 by FP and F14 in B-100 units. To replace F20 (5A) by F20 (4A) in all
the units "except B-100"
(04-2008) To update electrical diagramsfor the V-100/200/300 MAX 10/20/30/50, V-400/500 MAX
20/50, V-500 MAX TC 20/50 and V-500 AC 10/20 units
(10-2008) Add V-100/20 and V-100 MAX 20/50. To update electrical diagrams for V-100/200/300
MAX 10/20/30/50, V-400/500 MAX 10/20/30/50 and V-500 MAX TC 10/20/30/50 units.
To update F21
and F14. To eliminate DAS connection.
To Next Page
Loading...
Need help?
General
