Thermo King T- series Manual

Maintenance Inspection Schedule
52
Maintenance Inspection Schedule
Inspection and Service intervals
Inspection and Service intervals are determined by the number
of unit operating hours and by the age of the unit. Examples are
shown in the table below. Your Dealer will prepare a schedule
to suit your specific needs.
Interim
Inspection
Complete PM Full Service
A Service B Service C Service
Every 1000 hours
or every 6
months
(whichever
comes first)
Every 2000 hours
or every 24
months
(whichever
comes first)
Every 4000 hours
or every 48
months
(whichever
comes first)
Pretrip Inspect/Service These Items
• Run Pretrip Test (See “Operating the TSR-3
Controller” on page 33)
• Check fuel supply.
• Check and adjust coolant/engine oil levels.
• Listen for unusual noises, vibrations, etc.
• Visually inspect unit for fluid leaks. (fuel,
coolant, oil and refrigerant).
• Visually inspect unit for damaged, loose or
broken parts (includes air ducts and
bulkheads if so equipped).
NOTE: For further best practices, please go to
www.europe.thermoking.com/best-practices

Thermo King T- series Specifications

General

Refrigerant	R-404A
Voltage	12V/24V DC
Defrost	Electric or Hot Gas
Model	T-series
Cooling Capacity	Varies by model
Power Source	Diesel Engine or Electric
Temperature Range	-29°C to 24°C
Control System	Microprocessor-based
Fuel Tank Capacity	Varies by model
Dimensions	Varies by model
Weight	Varies by model