Compressor and Clutch Maintenance (Rev 1/99)
83
Shaft Seal Installation
Before installing a shaft seal inspect it carefully (see Inspec-
tion).
1. Clean the section of the front cylinder head that holds
shaft seal.
2. Apply clean compressor oil to the new shaft seal and to
the front cylinder head. If the slip surfaces are dirty,
clean them with thinners, dry the clean surfaces and
apply clean compressor oil.
3. Place the seal guide (from the shaft seal kit P/N
204-805) on the end of the shaft.
Place Guide on Shaft
1. Seal Guide
4. Place the shaft seal on the seal guide and slide the
seal into the cylinder head.
Place Shaft Seal on Guide
5. Use the seal installer (from the shaft seal kit P/N
204-805) to press the shaft seal into the cylinder
head as far as possible.
6. Remove the seal guide from the shaft.
Press Seal Into Cylinder Head
1. Seal Guide
2. Shaft Seal
To Next Page