Thermo Scientific 380 User Manual

Model 370 Series
Steri-Cycle CO2 Incubator
Direct Heat with Sterilization Cycle
Operating and Maintenance Manual
7000370 Rev. 12

Thermo Scientific 380 Specifications

General

Brand	Thermo Scientific
Model	380
Category	Accessories
Language	English

Summary

Section 1 Installation and Start-Up

Control Panel and Operation

Overview of the control panel, keypad, and display functions for operation.

Utilities and Gas Connection

Initial Configuration and Startup

Steps for starting the incubator and setting key parameters like temperature and CO2.

Section 2 Calibration

Temperature Calibration

Procedure for calibrating the incubator's temperature sensor.

CO2 Sensor Calibration

Steps for calibrating CO2 sensors (T/C and IR) using independent instruments.

Relative Humidity Calibration

Section 3 Configuration

Alarm and Reminder Configuration

Settings for audible alarms, HEPA filter reminders, and access codes.

Temperature and CO2 Alarm Settings

Define low/high alarm limits and relay trip for temp and CO2.

Humidity and Display Settings

Section 4 Alarms

Alarm Types and Descriptions

Alarm Fault Explanations

Section 5 Routine Maintenance

Cleaning and Exterior Care

Major Components and Sterilization Cycle

Section 7 Specifications

Temperature, Humidity, and CO2 Specifications

Detailed technical specifications for temperature, humidity, and CO2 control.

Construction, Electrical, and Safety Specs

Section 9 Electrical Schematics

Power Distribution and Component Schematics

Signal and Communication Schematics

Section 10 Warranty Information

USA Warranty Terms and Conditions

Details of the warranty period, coverage, exclusions, and contact information.