Why does the temperature fluctuate in my Thermo Scientific Laboratory Equipment?
If the temperature in your Thermo Scientific Laboratory Equipment fluctuates, ensure the cold control is set correctly. Also, make sure the condenser is clean. If the issue persists after checking these, contact an authorized service representative.
What to do if my Thermo Scientific Laboratory Equipment unit warms up?
If your Thermo Scientific Laboratory Equipment unit warms up, start by ensuring the door is completely closed and checking the door seal. Allow sufficient time for the unit to recover after loading warm products. Verify that the unit is receiving the correct voltage. If the compressor isn't running and the power failure alarm is on, have an electrician check the voltage. If the alarm is off, contact technical support. If the compressor is running, check for icing on the evaporator. If icing is present without airflow, or if there is airflow, contact technical service or an authorized service provider.
How to troubleshoot a Thermo Scientific Laboratory Equipment that does not operate?
If your Thermo Scientific Laboratory Equipment isn't operating or the Power Failure Indicator is on, ensure the cord is securely plugged in. For refrigerators (excluding undercounter and sliding door models), check the double pole circuit breaker next to the power inlet and cycle it OFF then ON. Test the outlet with another appliance and verify the voltage is correct for your unit. If the outlet is dead, check the circuit breaker or fuses.
How to troubleshoot a Thermo Scientific Refrigerator that won't turn on?
If your Thermo Scientific Refrigerator isn't working or the Power Failure Indicator is on, start by ensuring the power cord is securely plugged into the outlet. Next, test the outlet by plugging in another appliance to see if it's functioning. If the outlet is dead, inspect the circuit breaker or fuses.
What to do if my Thermo Scientific Revco is getting warm?
If your Thermo Scientific Refrigerator warms up, make sure the door is completely closed. Also, if you recently loaded warm items, give the unit time to adjust. Check that the unit is receiving the correct voltage; if not, consult an electrician. If the compressor isn't running and the power failure alarm is on, have an electrician check the voltage. If the compressor is running but there's icing on the evaporator and no airflow, contact technical service because the evaporator fans might not be working. If the compressor is running and there's airflow behind the evaporator, contact an authorized service provider or call the technical support hotline.
Why is the temperature fluctuating in my Thermo Scientific Refrigerator?
If the temperature in your Thermo Scientific Refrigerator is unstable, first ensure the cold control is properly set. Next, check that the condenser is clean. Finally, examine the system's high-pressure cut-out button, which is protected by a rubber boot. To reset it, depress the button, using a blunt instrument to prevent damage to the boot.
General| Brand | Thermo Scientific |
|---|---|
| Model | Revco |
| Category | Refrigerator |
| Language | English |
To Next Page
