Mulriskan
EX
software comprises program modules, software packages which are sombinationr: of
measurement and calculation modes.
.
.
The
following program modules are available:
1.
Primary
ElA
software
2.
Aalutination software (optional)
3.
Cut
off sohare (optional)
4.
Cubic spline software (optional)
ule
1:
Ptimary
EIA
This software
is
a basic sohare to perform
EIA
measurements. It includes the following measurement m
absohance, dual wavelensh, two point, kinetic, muttivawelength mode and computer control.
The
following calculation modes can be selected: factor, linear standard, standard line, limit, double limit,
range, column subtraction and point to point calculation.
ule
2:
Agglutination software (optional)
This module enables agglutination measrlrements A special optics (pmhole optics)
is
taken into use.
20
readings are taken
reach well. Results are sent via interface for further processing.
Module
3:
Cut off software (optional)
There are different cut off calculations avatlablc in this module: double limit, range, fixed cur off and floating
cut off.
Module
4:
Cubic spline (optional)
Measurement modss: available are absorbance, dual wavelength, two pint and kinetic
Calculation mode: available
is
cubic spline.
Changing between modules occurs by first pressing the
SHIFT
key and then the
ENTER
key
More memory capacity
is
offered by a programmable program card which can
he
plugged-in to the instmment.
med
by
Labsystems upen request.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
