CTION:
sults of column
I
are subtracted from rssults of column
2,
resulis
column
3
are subtracted from results of column 4,
etc.
or vice
versa. The measurement parameters, calculation parameters an
absorbance dixerences of every other column are sent
in
the built-in
printer or via the inleiface.
Parameter:
1-2
3-4...
or
2-1
4-3
...
The user enters the concentrations of the standards and Mulriskan
EX
calculates a piece wise linear standard curve with the help of these
standards. Measured absorbances are converted to concentration units
by the use of this curve. The mmiasuretnent parameters, calculation
parameters and concentrations obtained are sent to the built-in printer
or via the interface.
If
the piece wise linear standard curve is not monotonous, the text
NON-MONOTONOUS curve will be printed and the results are
incorrect.
Parameters:
Up to
8
standard solutions
can
be incorporated on the plate in up to
3
repticates.
I
STD
ON
EVERY
PLATE
/
Standard on every plate
(I
S1D
ON EVERY PLATE) or
2
RETAINED
STT)
retained standard
(2
standard curve of th
used) can
be
selected. If retained standard
is
selected
1
USE
OLD
LW
I
2
NEW
LINE
NOW wit1 be asked before readin
the next plate.
lutinalion Software (optional)
X
to computer. Enter to module
2
in Multiskan
EX.
Choose the filter, blanking and
puler contrd from computer. Starl the measurement.
20
readingdwell will
be
taken and
sent to the computer.
The following measurement modes are available in tnadule
3:
1
Absorbances are measured at one wavelength.
2
DUAL WAVELENGm: Absorbances are measured using two wavelengths:
Results of the second measurement are subtracted from results of the
first measurement.
3
TWOPOW:
Absorbances of the plate are measured at two separate
Results of the first measurement
are
subtracted from th
second measurement.
Rates of absorbance change are measured.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
