20
measurement
parameters can
be
selected:
Yn measurement modes
1,
2,
3
and
4.
Enter the wavelen@h(s) ofthe
filter(s) or the filter nunlber(s) (see
4
FILTER
3.6
General parameters).
MG
POSSIBIEITIES:
The following blanking possibilities
arc
available in mo
and
4:
1
NO
WFAGEMT
BLANK
2
STNGLE
WELL
REAGENT BLANK
-
blank well
is
entered
3
COLldMNMEANELA
-
blank column (1-12)
is
entered
-
average ofthe blank values
(8)
of
the column is used
-blank column (1-12) is entered
-
each row
will
have an lndlvldual blank value wh~ch
is
used
5
ROWMFANBLANK
-blank row
(A-li)
is entered
-
average of the blank values (12) ofthe
row
is used
-
each column will have an individual blank value which is use
1
BL
ON
EVERY
PI,
/
2
2
ALL
RESULTS:
TOTAL
Blanking on evcry plate
(1
BL
ON
EVERY
PL)
or retained blank
(2
RETAINED
BLANK,
blank value of
a
former plate is used) can
also be selected. Kretained blank is selected,
1
USE
OLD
BLA
NEW
BLANK
NOW will be asked before reading the next plate.
In modes
2,
3
and
4
final results
(e.g.
absorbance differences) or also
intermediate results
(eg.
absorbances with filter
I
and filter
2)
can
selected.
Time between successive measurements of the plate. Mir
'
~nterval time is
5
s,
maximum
100
min.
INTERVAL
parameter can be selected in modes
3
and
4.
Enter the interval time
as
PO<.=,
(XX
=
m~nutcs,
W
=
seconds).
NOTE:
When the kinetic measurement and
ALL
RESULTS are selected
and results are transm~tted via the RS-232C interface, the ac
minimum interval time is dependent on the baud rate used: the
lower the baud rate, the slower the intermediate res
transm~tted. This means
that
the interval time has to
enough for the instmment to be able
to
transmit the intermediate
results during the selected interval time.
Example: With baud rate
4800
the minimum interval time
is
6-7
depending on the
printer
used.
Time before measurement is started. Minimum lag time
is
0
s,
maximum
100
min.
LAG
TIME parameter can
be
selecte
Enter the lag time as
=
minutes,
YY
seconds).
Time during which the reaction
is
followed.
Minimum total time
is
5
s,
maximum
I00
min.
TOTAL
TTME
parameter can be selected in mode
4.
Enter the total time as
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
