Time between successive measurements of
t
interval time is
5
s, maximum 100 min.
parameter can be selected in modes
3
and
4.
Enter the interval time
as
XX.YY,
(XX
=
minutes,
W
=
seconds).
NOTE:
When the kinetic measurement and iBLL
and results are transmitted via the
-232C inle&ace, the actual
minimum interval
time
is depend
on the baud rate used:
the
lower the baud rate, the slower the intermediate results are
transmitted. This means
that
the interval time
has
to
enough for the instrument to be able
to
transmit the intermediate
results during the selected interval time.
Example: With band rate 4800 the minimum interval time
is
6-9
depending an the printer used.
Time before measurement
is
started. Minimum lag time is 0
s,
maximum 100 min. rameter can
be
selected in mode
4.
Enter the lag time a minutes,
W
=
seconds).
Time during which the reaction is followed.
Minimum total time
is
5
s,
maximum
100
min.
TOTAL
TME
parameter can be selected in mode
4.
Enter the total time as
XX.
W,
(XX
=
minutes,
W
=
seconds)
The following calculation modes and calculation parameters can
be
selected in module
4:
1
P.IQCALCaATIOM
Results are sent as absorbances to built-in printer or via the interface.
2
CUBIC SPLI
Cubic spline is a sigmodial cuwe used
for
example with hormones
and tumour markers.
Parameters:
NO
OF
SmS
2
2
to
8
Standards
is
allowed.
NO OF
WPL
1
I
to
3
replicates is allowed.
STANDARD
1
0.000 Enter concentration of stanciard
I.
1
REPL
1
A1
Enter lacation(s) of standard
1.
0.000 Enter concentration
of
standard
2.
A1
Enter location(s) of standard
2.
AINED
STArn
l
UNIT no unit,
Ull,
IU/I,
mlUfl,
gn,
mgA, m
&ml, nglml, mmalfl, ymoVI, nmoVl
1
scale L1NLM
2
scale LWiLOC
3
scale LQGiLM
4
scale EOGkOG
After measurement and data transfer
it
is asked
if
the
results are
accepted or
if
a new fit is required:
I
ACCEPT WSULTS
2
NEW
FIT
If results are accepted, the instment goes to
fit
is
required, new scale parameters have
PWNT
key
pressed. The new results
will
retained standard
is
used
I
USEOLD
CURVE
2
NEWCmWNOW
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
