Thermo LabSystems Multiskan EX - Page 124

Figure 13. Changing the lamp
The
fises are located at the rear of the initmment (Fig.
Switch the power off.
Unplug the instnlment and disconnect the power cord from the power input socket.
Unscrew the caps
of the fuse holders (Fig. 14).
Replace the blown fuses with the same type.
Screw
the caps back onto the fuse holders.
wer cord and switch the power on.
Figure 14. Changing the fuses
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com