Thermor Bilbao - Installation; Preparing the Installation of the Device; Fixing the Hanging Frame to the Wall

21
Installation
Installation guidelines
- This device was designed to be installed in residential premises. In any other case, please call your distributor.
- Installation must comply with the standards currently enforced in the country of use.
- The device must be supplied with 230V single-phase 50Hz.
-
In damp areas such as bathrooms and kitchens, you must install the connec-
tion box at least 25cm above the floor.
Keep the device away from an y draughts that may interfer e with
its operation (e .g.: under a centrally controlled fan, etc...).
Do not install the device under a fixed socket.
Comply with the minimum distances from any furniture units when positioning the device.
PREPARING THE INSTALLATION OF THE DEVICE
Volume 1 No electrical device
Volume 2 Class II IPX24 electrical device
Volume 3 Class II electrical device
Volume
3
Volume
2
60 cm
60
cm
60
cm
3m
2,25 m
Volume
1
FIXING THE HANGING FRAME TO THE WALL
Place the hanging
frame on the floor
against the wall. Lo-
cate drilling
points A.
Refit the hanging
frame, lining up with
drilling points A to
find drilling points B
(you can also use a
level).
Drilling points A show the position for the lower fastenings. Drilling points B show the position for the upper fastenings.
Drill the 4 holes and insert the wall plugs.
Use suitable wall plugs when fitting on a specific support
(e.g. plasterboard wall).
Position the hanging frame and screw it down.
1
2
3
4
Drilling
points A
Drilling
points A
Drilling
points B
GB