Leaflet no. 07032/062001
2. 07031 Flush tube
D.
Go inside nozzle
with the long nose
pliers and, push it
into the water tank.
Nozzle
E.
Bend the new flush tube into a horseshoe shape and place an
elastic band around it half way down, forcing it to remain in
this position.
For taking out the bellow see point A, B and C on the front page.
F.
Once in view the nozzle
may then be gripped with
a long nose pliers and
pulled back into the toilet
bowl through the hole.
G.
When pulling the nozzle through the hole,
make sure that the small rib on the nozzle
is pulled inside the toilet bowl.
Due to the horseshoe shape of the flush tube, when refitted, the
nozzle will be guided back up towards the hole at the entrance of
the bowl.
Small rib
Note : Before refitting,
remove the elastic band.
2