MAINTENANCE
We recommend an annual service by an authorised service agent to maintain efficient
appliance performance. In between annual service the appliance needs little maintenance
other than cleaning. All parts should be cleaned using warm soapy water. Do not use
abrasive cleaners, steel wool or cleansing powders. When cleaning the burner ring it is
essential to ensure that the holes do not become blocked.
The control knobs are a push fit and can be removed for cleaning. They are
interchangeable without affecting the sense of operation.
Regulations and Standards
In your own interest of safety, it is law that all gas appliances are installed and serviced by
an approved competent person, in accordance with the local and National/European
standards in force Failure to install the appliance correctly could invalidate any warranty or
liability claims and lead to prosecution. Particular attention shall be given to the
requirements regarding ventilation. Read the instructions before installing or using this
appliance.
Ventilation
This appliance is suitable for installation into Holiday Homes, Touring Caravans and Boats.
In all cases the national standards with regard to ventilation for the particular vehicle into
which the appliance is to be installed must be adhered to.
The European Standard EN1949 - "Specification for the installation of LPG systems in
leisure and other road vehicles", specifies appliances be installed in accordance with the
manufacturer’s instructions, including the adequate provision to avoid the accumulation of
un-burnt gases. We recommend a gas dispersal hole venting to the outside, with minimum
size Ø12mm, maximum Ø25mm, which should be baffled to prevent direct draughts to the
appliance.
Location of Appliance
This appliance maybe installed in a kitchen/kitchen diner but NOT in a room containing a
bath or a shower. LP gas appliances must not be fitted below ground level. e.g. in a
basement
Position
A cut-out should be prepared as shown in the enclosed diagrams – Figs. 1 & 2. The
location of the cut-out MUST comply with the dimensions shown and include a gas
dispersal hole venting to the outside. We recommend the dispersal hole is baffled and
positioned as shown in the diagrams. Do not locate the dispersal hole directly below the
oven burner. A warning notice located near the dispersal hole with the following text is
recommended.
WARNING
Under no circumstances should the gas dispersal hole be obstructed.
The appliance should be fixed in place using the fixing screw positions located in each
side of the Oven opening. Make sure the appliance is fully home in the cabinet/aperture
before fixing in place.
To Next Page
Loading...
