Third Reality Smart Bridge MZ1 - Setup with Smartthings

Compatibility:
SmartThings App version 1.8.01.22 or higher. iOS SmartThings App ver-
sion 1.7.02.16
Matter-supported Controller: SmartThings Hub V2& V3, Aeotec Smart
Home Hub
Launch your SmartThings App. Tap + to Add device., Choose Matter.1.
Scan QR code on your device.2.
Select a hub to connect your device.(You need to Add to “iCloud Ac-
count” in IOS, then create Accessory Name, then Continue)
3.
Set a name to add the device.4.
Press the reset button through the pinhole with a pin to enable
Zigbee pairing, the Zigbee indicator of the Matter bridge truns into
blue blinking, put THIRDREALITY Zigbee devices into pairing mode
to add devices.
5.
Create routine with the Zigbee devices added through the Matter
bridge.
6.
To connect the device to another Matter certified ecosystem app, go
to the app of the first ecosystem to generate a new setup code. Go to
the Device Settings page, tab Share with other services then Share
device, there will be QR code and a numeric code. Launch the app of
another Matter certified ecosystem, follow the setup instruction to
enter the setup code and follow the app instructions to complete the
setup.
7.
Setup with SmartThings
22