Third Reality Smart Bridge MZ1 - Setup with Alexa

Note: It is highly recommended to download and install 3R-Installer
app on your phone first, follow the instructions below to setup the
bridge in the 3R-Installer app, then get the setup code and add the
bridge to your Alexa through multi-admin. You can also Scan the QR
code to add the bridge to your Alexa directly.
17
Alexa App version:
Android: 2.2.521848.0 or later for build version, and 2023.15 or later for
APP version
IOS: 2.2.548660 or later for build version, and 2023.15 or later for APP
version
1. Setup the Bridge with 3R-Installer App, copy the setup code of the
Matter bridge in 3R-Installer App.(Code effective duration: 3 min, see
Setup with 3R-Installer App)
Make sure your Alexa speaker is connected to the same Wi-Fi net-
work, launch your Amazon Alexa App, tab + in the up right on the
device page to Add Device, scroll down the the list and tab Other,
choose matter, try MUMERIC CODE INSTEAD to ENTER CODE, and
follow the instructions to add the bridge and pre-connected devic-
es.
2.
Create routines with the devices.3.
Setup with Alexa