Third Reality Smart Bridge MZ1 - Page 6

Scan the Matter QR Code and follow the on-screen instructions to
configure the Wi-Fi network.
5.
After the network configuration is completed, tab the bridge icon to
enter the device page, tab Check Updates for firmware updates.
6.
Tab Bridge Zigbee Devices and put the Zigbee devices into pairing
mode, pair the THIRDREALITY Zigbee end devices to this bridge.
After device configuration, you can find the Zigbee devices on the
Smart Bridge device page, tab the device icon to enter the device
page, you can Check Updates for firmware OTA.
7.
Tab Link With Matter Enabled Services, copy the Manual Setup Code
or Scan the QR Code within 3 min, then you can add the bridge to
other Matter supported ecosystems through multi-admin.
8.
Tab Bridge ZIGBEE Devices to pair more THIRDREALITY Zigbee devic-
es to the bridge.
9.
Tab Matter Reset It is highly recommended to download and install
3R-Installer app on your phone first, follow the instructions below to
setup the bridge in the 3R-Installer app, then get the setup code and
add the bridge to other Matter supported ecosystems through
multi-admin. to remove the bridge from your Wi-Fi router. Zigbee
devices connected to the bridge will remain connected. You can use
this code to set up the Wi-Fi for the bridge through 3R-Installer App
on your phone connected with another Wi-Fi router.
10.
04