Assembling the Hi-hat stand
Assemble the hi-hat stand as shown below.
To attach the hi-hat controller and hi-hat to the hi-hat stand, complete the following steps.
1. Loosen the Allen screw on the hi-hat connector piece with the drum key. Turn the top counterclockwise and remove the
items upwards.
2. Put the hi-hat on the lower part of the connector piece. Put the parts removed in the previous step back onto the connector
piece and retighten the Allen screw.
3. Put the hi-hat controller onto the hi-hat stand.
4. Insert the hi-hat with the connector piece onto the hi-hat stand. The distance between the hi-hat and the hi-hat controller
should be 15 mm to 20 mm.
5. Tighten the wing screw on the connector piece.
Assembly
MPS-850
13
To Next Page
Loading...
