MICRO SYSTEM
MIC200
TROUBLESHOOTING AND CLEANING
• The power supply cable is
disconnected.
• Correctly connect the power supply cable to
the mains socket.
• The external source equipment is off. • Turn the external power source equipment on.
• No disc has been inserted into the tray.
• The disc in the tray cannot be read.
• The disc is upside down.
• The disc is not inside the guide.
• The disc is dirty.
• Place a disc in the tray.
• Place a legible disc in the tray.
• Position the readable side of the disc
downwards.
• Correctly position the disc on the tray, inside
the guide.
• Clean the disc.
• The remote control is not pointed
towards the appliance sensor.
• The remote control does not activate
the appliance.
• There is an obstacle between the
remote control and the appliance.
• The remote control batteries are at.
• Point the remote control towards the
appliance sensor.
• The remote control has an effective range of 5
metres or the angle of aim is not correct.
• Remove the object.
• Replace at batteries with new ones.
• Unplug the appliance before cleaning it.
• Remove ngerprints and dust with a soft and slightly damp cloth. Do not use abrasive products or solvents that may
damage the appliance’s surface.
• If it is not used for a long time, unplug the appliance and remove the batteries.
TECHNICAL SPECIFICATIONS
• Remote control power source: 2 LR3 (AAA) 1.5V batteries (not included).
•Mains adapter: Input: 100-240V ~ 50/60Hz - 1.0A / Output: 15V/2500mA.
• Frequency range: FM: 87.5 - 108.0 MHz
• Consumption: 10W maximum
is a trademark of TECHNICOLOR S.A. used under license by:
Parsons International France - 19 Boulevard Albert Einstein
77420 Champs sur Marne - France
: Unit design and specications are subject to change without notice. The manufacturer reserves the right to make the
necessary improvements.
Monday to Thursday (from 9 am to 18 pm) and Friday (9 am to 3:30 p.m.)
N°Azur
(+33
)
0825 745 770
call rate according to operator
www.thomsonaudiovideo.eu
To Next Page
Loading...
