3 SpeedTouch™ for Microsoft Windows
3EC 36716 BAAA TCZZA Ed. 01
15
The Plug-and-Play
compliant installation
As an alternative to the SpeedTouch Setup wizard (application) installation you can also
install the STUSB using the Plug-and-Play compliant installation.
Installation results After you have correctly followed the STUSB installation procedures, the following
folders and icons are added to your system:
• SpeedTouch USB program folder:
The SpeedTouch USB Diagnostics application is added.
• Desktop SpeedTouch Dial-up icon:
A SpeedTouch Dial-up icon is added to your desktop.
• System tray SpeedTouch status icon:
An STUSB status icon is added to the system tray, allowing instant status informa-
tion of the STUSB.
Step Action
1 Connect the STUSB to the ADSL wall socket and the PC.
Note: ADSL must be available, as well as the appropriate central splitter or
distributed filters.
2 Windows will automatically recognize the STUSB.
The Windows 'Found new Hardware' wizard pops up. This wizard will guide
you through the installation procedure.
Follow all the instructions. In most cases you only have to click Next to
proceed with the installation procedure.
3 At some point the STUSB Installation CD-Rom will be requested. At this
point the SpeedTouch Setup wizard (application) will continue with the instal-
lation of the STUSB software and applications.
4 The installation finishes with setting up STUSB's ADSL Wide Area Network
(WAN) connectivity.
The installation of the STUSB is now finished. The STUSB is now prepared for
connecting you to the Internet. (See section “3.2. Using the SpeedTouch™”
on page 16).
To Next Page
Loading...
