E-DOC-CTC-20060911-0081 v1.0
Chapter 2
Basic Installation
11
3 Make one of the following connections:
Connect the yellow RJ-45 Ethernet cable to the Ethernet port on your Thomson Gateway and the
other end to the computer’s Ethernet port.
Connect the USB cable to the indicated USB port on your Thomson Gateway and the other end to the
computer’s USB port.
For wireless networking, plug a wireless card or adapter into your computer.
4 Once the hardware is installed and connected to the Thomson Gateway, the procedure continues with
configuring your Internet connection.
Proceed with “ Configuring the Internet connection” on page 12.
i
In case of problems or for advanced information, see “2.4.2 Wireless Setup” on page 25.
i
If the wizard does not detect a connection, an error message will be displayed. Refer to “The
wizard does not detect a connection” on page 39.
To Next Page
Loading...