Chapter 1: Connections and Setup
8
Your PC: Installing a TCP/IP Stack
Follow these instructions to install the TCP/IP protocol stack on one of your PCs only after a
network card has been successfully installed inside the PC. These instructions are for Windows
Me. For TCP/IP setup under Windows NT, 2000, and XP, refer to your Windows documentation.
1. Click the Start button. Choose Settings and then Control Panel.
Fig. 2
2. Double-click on the Network icon to bring
up your Network window. Select the
Configuration tab.
3. Click the Add button.
4. Double-click on Protocol.
Fig. 3
5. Highlight Microsoft under the list of
manufacturers.
6. Find and double-click TCP/IP in the list to
the right (see Figure 3).
To Next Page
Loading...
