6
Installation location requirements
Before installing the appliance, the location characterised as follows shall be selected:
‒ Rigid, dry, and level surface
‒ Avoid direct sunlight
‒ Sufficient ventilation
‒ Room temperature is above 0°C.
‒ Keep far away from heat resources such as coal or gas burning appliances.
Levelling the appliance
Levelling the washing machine properly prevents excessive noise and vibration.
Install the appliance on a solid and level floor surface.
If the floor is uneven, turn the adjustable feet as required.
Never put cartons, wooden blocks or similar materials under the feet.
1. Loosen the lock nuts with a spanner.
2. Turn the adjustable feet to adjust the height.
Make sure that all four feet are stable and resting on the floor and then check that the appliance
is perfectly level using a spirit level.
3. Tighten the lock nuts.
Installing the bottom cover
Paste the sound
absorption pad onto the
bottom plate.
Peel off the backing paper
from double-sided tapes
at four sides of the
bottom plate.
Tilt the appliance
backwards (tilting angle:
40°) and insert the bottom
plate.
Press the double-sided
tapes to secure the
bottom plate onto the
appliance.
To Next Page
Loading...
