7
Electrical connection
Your washing machine works with 220-240V and 50Hz.
Electrical connections must be carried out by a qualified technician in compliance with the local safety
regulations.
Your washing machine must be properly earthed. We will not be held responsible for any damage that
may occur as a result of usage without correct earth connection.
Do not use extension leads or multi-sockets.
The appliance must not have an external switching device such as a timer or connected to a circuit that
is regularly switched on and off.
Do not pull the plug out of the mains outlet if there is flammable gas around.
Connecting the hoses
Connecting the water supply hose
The appliance must be connected to a cold water supply.
Make sure that there is no kink on the hose and that it is not crushed.
1. Screw one end of the inlet hose on the
back of the appliance.
2. Connect the other end of the inlet hose to a ¾”
threaded tap.
NOTE :
After completing connection, turn on the tap slowly and make sure there are no leak.
Do not twist, squash, modify or cut the hose.
To Next Page
Loading...
