What to do if sparking but no flame ignition in Thor Kitchen Ranges?
If there is sparking but no flame ignition in your Thor Kitchen Ranges, the gas shut-off valve may be in the ‘OFF’ position. Turn the shut-off valve to the ‘ON’ position.
What to do if burner flames are very large and yellow on my Thor Kitchen Ranges?
If the burner flames are very large and yellow, it could be due to several reasons: clogged burner bezel ports, burner ports or burner caps not positioned properly, using the wrong type of gas, or a faulty regulator. Try cleaning the burner bezel ring ports with a straightened paper clip, needle, or wire. Also, remove and carefully re-install the burner bezel and caps. Ensure that the type of cooktop matches the natural gas supply. Check the regulator installation, replace the regulator, or set the regulator for the proper gas.
Why do some burners not light or flames don't burn all around the burner cap on my Thor Kitchen HRG4804U Ranges?
This issue may occur if the burner parts or igniters are wet, dirty, or misaligned. Ensure that the burner parts and igniters are clean, dry, and correctly assembled. Refer to the ‘Care and cleaning’ section for instructions.
What to do if there is a power failure and I want to use my Thor Kitchen Ranges oven?
The oven cannot be used until power is restored if there is a power outage in your home or neighborhood.
What to do if my Thor Kitchen HRG4804U burners have very large and yellow flames?
If the burner flames on your Thor Kitchen Ranges are very large and yellow, the burner bezel ports may be clogged, burner ports or burner caps might not be positioned properly, the cooktop may be using the wrong type of gas, or the regulator could be faulty or set incorrectly. Try cleaning the burner bezel ring ports with a straightened paper clip, needle, or wire. Also, remove and carefully reinstall the burner bezel and caps. Ensure the cooktop matches the natural gas supply. Check the installation, replace the regulator, or set the regulator for the proper gas.
What to do if my Thor Kitchen HRG4804U burners flame goes out at low setting?
If the burner flame on your Thor Kitchen Ranges goes out at a low setting, there may be low gas supply pressure, or the air intake holes around the knobs may be obstructed. Contact your gas company to check the gas supply pressure and remove any obstructions around the knobs.
Why won't my Thor Kitchen HRG4804U burners light?
If some of the burners on your Thor Kitchen Ranges won't light, the burner parts or igniters may be wet, dirty, or misaligned. Ensure that the burner parts and igniters are clean, dry, and correctly assembled.
What to do if igniters spark continuously after flame ignition in Thor Kitchen Ranges?
If the igniters in your Thor Kitchen Ranges spark continuously after the flame ignites, the power supply polarity may be reversed, or the igniters may be wet or dirty. Correct the polarity or dry/clean the igniters.
What to do if my Thor Kitchen Ranges oven will not heat?
Make sure that the oven settings are correct. Follow the mode selection and clock settings as specified in the Oven Operation section of the manual.
How to fix Thor Kitchen Ranges burners that will not light?
If some burners on your Thor Kitchen Ranges won't light or the flames don't burn all around the burner cap, it's possible the burner parts or igniters are wet, dirty, or misaligned. Ensure the burner parts and igniters are clean, dry, and correctly assembled. Refer to the ‘Care and cleaning’ section for detailed instructions.
General| Brand | Thor Kitchen |
|---|---|
| Model | HRG4804U |
| Category | Ranges |
| Language | English |
To Next Page
