113
5. Hatch cover. Open this and pass your city pressure hose through. Close with hose
passing through small opening in the cover.
6. Exterior faucet. For mixing the water temperature for the exterior shower head.
The toilet installed in the motorhome is connected to the pressurized fresh water
system. It uses a foot pedal to flush and add water to the bowl.
To flush the foot pedal style, depress the pedal all the way until rinse clears the bowl.
Be sure to release the lever slowly. Movement of the flush lever opens the waste valve
and allows the water to pass into the holding tank.
To add water to the bowl, depress the pedal half way. This will open the water valve
and leave the flush lever closed.
Note: Unnecessary frequent flushing of the stool will quickly deplete your
fresh water supply and fill your holding tank. If the black water tank becomes full,
you will no longer be able to flush the stool until the tank can be drained.
Note: Follow the toilet manufacturer’s recommendations supplied with the
toilet for cleaning and maintenance. If you have a toilet that differs from the description
given here, make sure to follow the manufacturer’s advice for operation.
1. Connect sewer hose.
2. Open dump valve; let tank empty.
3. Attach garden hose to water inlet labeled “Sewer Valve Must be Open
When Using This Inlet”. With faucet at full pressure, ush for about 2 minutes
or until water runs clear from discharge hose.
4. Disconnect garden hose from faucet and lay on ground to allow water to
drain from the system before detaching from water inlet.
Water Systems
No Fuss Flush
TOILET
CAUTION
DO NOT ALTER THIS SYSTEM IN ANY WAY, SUCH AS BY
ADDING CHECK VALVES, ETC. DON’T USE the same
hose to ll your potable (fresh) water tank that is used for
the No-Fuss Flush.
To Next Page
Loading...
