47
Controls and Operations
STEERING WHEEL
ADJUSTMENT
The steering wheel can be moved to allow additional room for entering and exiting
the driver’s seat, as well as for selected driving positions. To tilt the steering wheel,
pull the adjustment lever toward you and move the steering wheel to where you want
it. Release the lever and the steering wheel will lock in the new position.
TURN SIGNAL/LANE
CHANGE/HIGH-LOW
BEAM
The lever on the left side of the steering column controls the turn signal with lane
change feature, as well as the Head lamp high/low beam toggle as well as the
windshield wiper and washer fluid dispersal.
The turn signal lever has two off-center positions, one positions upward (for right) and
one downward (for left). To signal a turn, move the lever all the way up or down. These
are latching positions. The lever will stay in one of these positions until the steering
wheel returns back to center as the turn is complete.
To change the head lamps from low to high beams, pull the same lever used for turn
signal operation up toward the driver and release the lever. This is a self-returning
action. Repeating this toggle action will return to the low beams.
HAZARD FLASHER
CONTROL
The hazard flasher control button is located on the steering column just behind the
steering wheel. To activate your hazard flashers, press the button. To turn off the
hazard flashers, press the button again.
Never attempt to adjust the steering wheel while the
vehicle is in motion. Loss of vehicle control could result.
To Next Page
Loading...
