124
Care and Maintenance
If you travel roads that have been salted for ice, wash your motorhome as soon as
possible. The most common causes of corrosion are accumulation of road salt, dirt,
and moisture in hard to reach areas under the motorhome. Make sure you wash
the undercarriage and wheel wells as well as the exterior of the motorhome. A good
automotive cleaner may be used occasionally to remove tree sap, road tar, insects and
industrial pollution that may damage surfaces. Do not use naphtha or turpentine. We
recommend that you wash your motorhome about every three weeks.
It is important to note that any nish will deteriorate with time. Dulling, fading and
yellowing will be increased by exposure to extreme sunlight, air pollutants, and
excessive moisture. Motorhomes located in warmer weather climates are more prone
to this type of premature fading. Surface weathering of berglass does not change
the strength of the berglass. Regular washing and waxing of exterior surfaces is the
best insurance against surface deterioration. If deterioration has occurred, check with
your dealer for the steps required to restore the nish. Bufng or even painting may be
necessary in extreme cases. Small cracks known as gel coat crazing are a common
characteristic of the gel coat nish and not warrantable defects.
Wax berglass surfaces at least once a year with a standard liquid or nonabrasive paste
wax. Make sure to follow the directions for use as outlined by the product manufacturer.
Make sure to wash and wax your unit out of the hot sun when the exterior surfaces are
cool. Storage of the recreational vehicle out of direct sun is also a primary way to help
preserve berglass nishes. Physical damage to fiberglass should be taken care of
immediately to avoid moisture from entering through breaks and causing problems
with interior walls and components. Cover breaks in the fiberglass with plastic, sealing
the edges with tape until proper repairs can be made.
Note: DO NOT use rubbing compound or any abrasive cleaner or cloth on
the motorhome. If using a tar and insect remover, make sure it is
safe for use on painted surfaces and decals.
Note: The exterior painted finish on the motorhome is of the finest quality.
Proper maintenance will assure a long lasting durable finish. Do not
wax or polish the exterior for the first 60 days.
Note: DO NOT dry wipe the surface; clean only with water and liquid
detergent.
Note: DO wax the sidewalls using nonabrasive automotive waxes or
cleaner/polishes developed for use on berglass boats, showers,
and tubs. Follow the directions on the package.
Proper care and maintenance of vinyl graphics or paint is critical in maintaining its
appearance. The following cleaning and maintenance recommendations should be
followed to ensure the maximum appearance and performance of your vehicle’s
custom designed nish:
When washing, ush the surface with water to loosen large particles of dirt and grime.
Fill a bucket with warm water (not to exceed 120 degrees F. (120°F)) and use a
mild detergent or a liquid car wash mixture. Follow manufacturer instructions on the
container.
Using a clean soft cloth or sponge and the liquid car wash mixture, wipe the entire
surface, using horizontal motions until it is clean. Rinse off the detergent with clean
water starting from the top and rinse downward until it is clean.
Dry your vehicle with a clean soft cloth or let the vehicle air dry.
EXTERIOR
GRAPHICS/PAINT
To Next Page
Loading...
