67
Controls and Operations
Keep people and obstructions clear of room when
operating.
Note: Make sure that there is adequate clearance to fully extend the room.
1. Apply the parking brake
2. Make sure ignition is in OFF position.
3. To extend the room, press and hold the ROOM CONTROL
SWITCH in the “OUT” position. When the room is fully
extended, release the ROOM CONTROL SWITCH.
Note: Releasing the ROOM CONTROL SWITCH will halt the operation of
the room.
1. Make sure to clear any obstruction in the slide-out area, and set
the parking brake.
2. To retract the room, press and hold the ROOM CONTROL SWITCH in
the “IN” position. When the room is fully retracted, release the ROOM
CONTROL SWITCH.
3. Install the room locking devices if equipped.
4. If the room will not retract, refer to the “Manual Retract Procedure”.
Manual retraction
1. Locate the included exible shaft in your owner’s packet.
2. Attach exible shaft to the 1/4” hex tting on the end of the motor.
3. Attach 1/4” socket & ratchet, or drill to the other end, and turn in the proper
direction to move the room.
4. If the cables tighten, and the motor is difcult to turn, REVERSE THE DIRECTION.
Over-torquing can happen, resulting in severe damage.
To Next Page
Loading...
