22 INITIAL STARTING UP
used, adjust the stylus pressure and the antiskating indicated to the corresponding specifications.
MAINS CONNECTION
An external switching power adaptor is supplied with this turntable.
There are the RCA jack on the rear panel of the turntable. You can use it to connect to your amplifier. You also
could switch the selector to “ON” or “OFF”, and connect the RCA plug to the “LINE” input of your amplifier.
01. Place the record on the turntable. If it is a 45 rpm, you need to place the adaptor on the record spindle.
02. Choose the playing speed.
03. Release the pick-up arm clip. If AUTO PLAY switch (13) on the back is set to ON motor starts turning automati-
cally once the arm is moved towards platter.
04. Place the cartridge vertically over the first track of the record the turntable starts turning.
05. Lower the cue lever to place the stylus in the groove
06. When playback is complete, push the cue lever to lift the tone arm and move it back to the arm rest. If AUTO
PLAY switch (13) on the back is set to ON motor stops automatically at the end of the record.
07. After finish the playback, please switch o the power to save energy.
To Next Page
Loading...
Need help?
General
