THORLABS DRV225 - Pin Assignments; Extension Cables

Rev B Jan 2020
Page 7
Chapter 3 Operation and Maintenance
3.5 Pin Assignments
Pin assignments for the male D-Type connector on the motor flying lead are described below..
Note a. The limit switch ground wire is connected to the motor body.
Fig. 3.4 Output Connector
3.6 Extension Cables
The motor is supplied with a 0.5 m flying lead and a 3 m (PAA613) extension cable. Additional extension cables are available
separately - see www.thorlabs.com for more details.
Pin Description Pin Description
1
Limit Ground
a
9 Ident (for Future Use)
2 CCW Limit Switch 10 +5 V
3 CW Limit Switch 11 Reserved for Future Use
4 Motor Phase B - 12 Reserved for Future Use
5 Motor Phase B + 13 + 5 V
6 Motor Phase A - 14 Reserved for Future Use
7 Motor Phase A + 15 Ground
8 Reserved for Future Use
5
10
11
15
6
1