Calibration & Measurement Module for OTKB/OTKBFM Chapter 2: Safety
TTN030035-D02 Page 2
Chapter 2 Safety
2.1. Safety Information
For the continuing safety of the operators of this equipment and the protection of the equipment itself, the
operator should take note of the warnings, cautions, and notes throughout this user guide, and where visible, on
the product itself.
The following safety symbols may be used throughout the user guide and on the equipment.
SHOCK WARNING
Given when there is a risk of injury from electrical shock.
CAUTION
Caution is given when there is a possibility of damage to the product.
WARNING
Given when there is danger of injury to users.
2.2. General Warnings
WARNING
If the product is used in a manner not specified in this user guide, the equipment may be damaged.
Specific care must be taken to ensure that the applied input voltage levels do not exceed the
product specifications and that any equipment connected to the output ports of the device is
compatible with the supplied output voltage levels.
WARNING
Before connecting the included power supply to the AC mains, make sure the correct line input
voltage for your region is selected. The selector is located on the back of the power supply housing.
! !