Adjusting the TRAVEL & resistance FORCE for the Brake pedal
To adjust the TRAVEL and resistance FORCE for the Brake pedal, you must remove the
transparent plastic pinch-hazard protector (protecting the brake pedal), and install the
included metal stop. By doing so, you will no longer benefit from the intended protection
against pinch hazards.
CAUTION:
To restore your protection against pinch hazards, you must remove the metal stop and
reinstall the transparent plastic pinch-hazard protector in its former location.
THRUSTMASTER® DISCLAIMS ALL RESPONSIBILITY FOR ANY INJURIES CAUSED BY
REMOVAL OF THE PINCH-HAZARD PROTECTOR OR INSTALLATION OF THE METAL STOP
- Unscrew the 2 screws holding the pinch-hazard protector on the brake pedal arm.
- Install the metal stop (23) at the rear of the brake pedal arm.
To Next Page
Loading...
