•
Starting at either end of the track, mark the end hole using a fine tip marker, and continue to
mark every other hole on the track.
2
•
Remove the tracks
from the roof.
3
•
Using the
7
⁄32" drill bit supplied, drill
a hole into each of the pilot holes.
•
Carefully blow away debris.
5
•
Remove backing from the self adhesive washers and apply to the bottom of the track.
Only place washers on holes that line up with the holes drilled in the roof.
6
•
Using the
1
⁄8" drill bit supplied, drill a
pilot hole in the center of each of the
marks.
4
•
Apply silcone into each hole.
7
•
With end caps inserted into
track, position track over the
holes and install screws at front
and rear.
8
W
ear safety glasses
during installation.
W
ear safety glasses
during installation.
To Next Page
Loading...
