•
Put self adhesive washers on to remaining screws and install them in to
the remaining holes.
9
•
Inside the shell, place the steel washer and locking hex nut onto the screw.
10
ROOF/TOIT
•
Tighten all screws using a
5
⁄
16
" wrench and the supplied 3mm hex key
.
• Two people are required for proper installation.
11
ROOF/TOIT
To finish the installation there are two options.
•
Attach a screw end protector onto
each screw.
• Cut off the bolt excess length and
place an acorn cap onto the nut.
12
A
B
Note: For mounting TK1 bases (not included), use all hardware (thick washer
, thin washer, spacer) included with TK1.
To Previous Page
Loading...
