Thümler Z3 - Special Programs

34
10) Special Programs
F (0) Mode
If F (0) Mode is set to “1“x will automatically be set to 0
If load will come to a special value (after touching the sample)
Used for compression tests
Constant Force Regulation
With key “8” you can switch to force regulation
With key “Menu” you can set force
For example, 5 N makes tension 5 N
For example, 5 N makes compression 5 N
If you press “Start” key, force regulation will be activated
machine drives slowly to this force
If you press again on key “8”, you will come back to normal
constant speed regulation
in constant force regulation modus you can change settings
depending on hardness of material from 1 to 10
Push button Menu of tensile tester
if material is weak push 1 reaction speed is high
if material is hard push 10 reaction speed is low