33
9) Upload Hexfile
The Hex Program in the single board computer can be changed (updated).
For this, the program serves "Loader.exe" and the file ...... hex "
However, please observe the setting values of the tensile testing machine for safety,
Note before!
After the loader is started, select port number then select the hex file.
The machine must be switched on, may not run in a test
the loader transfers the hex file to the machine and starts the program.
The current manuals and the latest software packages, see
http://www.grip-soft.de/
Questions or problems with the software, please send e-mail to
service@grip-soft.de
To Next Page
Loading...