30
8) INTERFACE USB
USB VCP communication for the family Z3-Z100 machines
The family of Z3-Z100 machines (3, 5, 10, 290, 50; 100 kN) can communicate with a PC via
USB Virtual Com Port. Speed of communication is fixed at 1562500 bps and can’t be change
by user. For connection, between the PC and the machine is used the standard USB A-B
cable. Cable should be not longer than 10 m.
General syntax of commands
All orders are created from UPPER CASE character (or two) in ASCII format, optional
parameter value with sign (if negative), point as decimal separator (if present) and dollar ($)
sign on end of each command.
Example of single order (new ‘Endpos’ value)
*
Between order character value and “end of order “mark is no space.
To Next Page
Loading...