3
ASSEMBLY / WING
1. Before you install the aileron servo you have to
decide if your e-Hawk will have Flaperons(FLPN)
or not.
If Flaperon function is applied, then it will require
2 Servo Extensions which are 15" long minimum.
(We recommend to set up the e-Hawk with
Flaperon if you have a computer radio with mix
function )
If Aileron function only is applied, then it requires 2
Servo Extensions plus a Y harness.
2. Cut away the covering at servo hatch and the hole
near the wing root where extension wire passes
through.
3. Use heat iron to tack down the covering at the
opening.
4. Glue the aileron servo tray ( square plastic piece)
on the wing sheeting with instant glue.
5. Connect the extension wire. You can tape it
together to prevent from disconnecting during
flight.
Wing Assembly
To Next Page
Loading...
Need help?
General
