3
RECOMMENDED TOOLS & MATERIALS
Adhesives:
Instant setting Cyanoacrylate adhesive (thin CA)
Slow setting Cyanoacrylate adhesive (thick CA)
10 Minute Epoxy (fast)
20-30 Minute Epoxy (slow)
Tools:
Model knife, 1/2” MASK tape
Small screwdrivers,medium screwdrivers
Scissors
Long nose pliers and diagonal cutting pliers
Drill and drill bits (1/16",5/64")
150 grid sand paper
Fine felt tip pen and soft lead pencil
Reamer
R/C System:
6 Channel Heli radio
GYRO system
Helicoptor:
Raptor 60~90 Suggested
TTR1115 - Precision Fueler Valve
TTR2174 - Built in Glow Plug Extension Wire
TTR4870 - Paptor 60
TTR4890 - Paptor 90
Adhesives - You will need two types of adhesives for
the MD-500 - Epoxy and Instant (cyanoacrylate)
adhesives. We recommend that you purchase both 5-
minute and 30-minute epoxy to cut down on assembly
time, but you can get by with only 30-minute epoxy if
time is not important.You will also need a small bottle of
both “Thick” and “Thin” instant CA adhesive.
Tools - Model assembly can be much easier if the
proper tools are used. Therefore, we have included in
our checklist to the left,a complete listing of all the tools
we used to assemble our prototype models.As you will
notice, many household tools can be utilized during
construction.
ITEMS YOU MAY NEED
To Next Page
Loading...
