INTRODUCTION
Introduction
Introduction.........................................................................................................................2
Parts Drawings........................................................................................................................4-5
Wing…………………..........................................................................................…….…...……...6
Tail........................................................................................................................................7-8
Motor………...........................................................................................………….....……........9
Radio..………........................................................................................………….....……..10
Cowling..………........................................................................................………….....……..11
Control Throw & Balance ......................................................................................................12-13
............................................................................................................................15
TABLE OF CONTENTS
A checklist is provided as below which will make shopping for these items easier.
OTHER ITEMS REQUIRED FOR ASSEMBLY
Adhesives: You will need the instant
(cyanoacrylate) adhesives and epoxy.
Thank you for your purchase of the Thunder Tiger 3D YAK 54 EP. You can make this proven 3D fun flyer
easily in doing any aerobatics and 3D maneuvers, includes Knife Edge, Hovering, Torque Rolls, Cobra...etc.
Very good for those who are interested in learning 3D-aerobatics or experienced 3D pilots who are looking
for a relaxed practicing plane that can be used both outdoor and indoor.
Radio: A 4-channel radio with 4 micro servos and mini
receiver are required. Suggest to use programable
radio so you can adjust the Exponential.
Battery: Recommend the use of a ACE Power Lipo
battery 3S1P 2200mAh(No.2808).
Brushless Motor: Recommend
motor.
OBL36/09-30A
2
Paper Towel
Hobby Knife
Ruler
Pen, Pencil or Marker
Phillips&Flat Head Screw Drivers
Scissors
Nose Plier
Drill Bit 1/8” (3mm)
TOOLS AND SUPPLIES NEEDED
Extension Wire: 2 pieces of extension wire in length
of 12” and one piece Y-cord.
Propeller: Recommended APC propeller 12x5E or
13x4E for normal flight and APC 12x6 E for high
performance 3D aerobatics.
ITEM REQUIRED
3
The 3D YAK 54 EP is designed for intermediate pilot minded. Before beginning the assembly read
the instructions thoroughly to give an understanding of the sequence of steps and a general awareness of the
recommended assembly procedures. Check the entire contents of your kit against the parts drawing and
photos to make sure that no parts are missing or damaged. This will also help you to become familiar with
each component of your plane. If you find that any of the parts are either missing or damaged, please contact
Thunder Tiger Distributors for Customer Service.
Controller: ACE BLC-40A ( No. 8027 ) is a perfect
controller that controlling OBL motor efficiently.
BLC-40A
To Next Page
Loading...
Need help?
General
