Page 8 <&(%$*4.8"4,7%H'*#$"&8#I%/7*,#*%4,77%JKLLLKLMMKNOPO1 Item 63585
?@<6AQ RS6;@ACRE D@CEA6E@ET6?6AFS
U"("83
E&$*- Only a licensed electrician and a licensed building
contractor can safely design and implement a grid
tie-in system. Any grid tie-in system must meet all
applicable building and electrical codes, and must meet
standards established by the area power company.
1. Run wires from panels, through weatherproof
grommets and into enclosure where power
inverter is located. Use wires of the proper
size and rating and use twist connectors
(not included) to connect wires.
2. Connect battery to power inverter according
to inverter’s instructions. U@;ECEVd Inverter
must be properly rated and designed for this
type of connection and power supply.
3. Secure all connections using terminals, or solder
all wire splices to ensure good connections.
4. Weatherproof all connections and route the wire in
a way that it will not be torn loose from the panel.
To Next Page
Loading...
