1
Table of Contents PAGE
DESCRIPTIONS OF EQUIPMENT AND OPERATION
Sport Timer 3000 Controller/Timing Computer 2
Infrared (IR) Beam Transmitter 3
Infrared (IR) Beam Receiver 3
Beam Alignment (ALWAYS do this for best results) 4
Big Display Scoreboards 4
Wireless Data Interface to Windows PC 5
LOW battery warnings 5
BASIC TIMING SETUPS
Manual Stopwatch 6
Single IR Beam at Finish Line, manual Start 6
Single IR Beam at Start Line, manual Finish 6
Single IR Beam at the Same Start/Finish line 7
Dual IR Beams at Separate Start and Finish lines 7
Multiple IR Beams for segment timing 7
Using Deadtime to disable Beams 7
Review times stored in memory 7
CONFIGURATION MENUS 8
Cloc Set Timer to count UP or DOWN 9
PAS Set Timer reset to zero, or resume on Start 9
Sond Set LOUD Beep Signal at Start and Stop 9
StEP Set speed of pre-setting times 10
Circ Enable Circuit Training Program 10
LAP Enable LAP Timing 10
SPLi Enable SPLIT Timing 11
ScLc Set rest period for Circuit Training Program 11
Strt Set START Deadtime 11
StoP Set STOP Deadtime 11
For Set data format for Wireless PC Interface 12
bAtt Display Sport Timer Battery Voltage 12
dFLt Reset to Factory Default Settings 12
TESt Wireless TEST mode 12
SPECIFICATIONS 13
APPENDIX 1 – Timing 101 – Typical Settings
14
APPENDIX 2 - Wireless PC Interface Manual 18
To Next Page
Loading...