Tibo PP100 - Important Safety Instructions; Safety Guidelines; Warning Information

4
Safety
1 Read these instructions.
2 Keep these instructions.
3 Heed all warnings.
4 Follow all instructions.
5 Do not use this apparatus near water.
6 Clean only with dry cloth.
7 Do not block any ventilation openings.
Install in accordance with the manufacturer’s
instructions.
8 Do not install near any heat sources such
as radiators, heat registers, stoves, or other
 apparatus(includingampliers)thatproduce
heat.
9 Protect the power cord from being walked
on or pinched particularly at plugs,
convenience receptacles, and the point
where they exit from the apparatus.
10 Unplug this apparatus during lightning storms
or when unused for long periods of time.
11 Referallservicingtoqualiedservice 
personnel. Servicing is required when the
apparatus has been damaged in any way,
such as power-supply cord or plug is
damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus
has been exposed to rain or moisture, does
not operate normally, or has been dropped.
12 Unit shall not be exposed to dripping or
splashing.
13 Do not place any sources of danger on the
 apparatus(e.g.liquidlledobjects,lighted
candle).
14 The mains plug is used as the disconnect
device, the disconnect device shall remain
readily operable.
15. Don’t put more than 30kg loading on top of
this apparatus.
Warning
1 Before operating this system, check the
voltage of this system to see if it is identical
with the voltage of your local power supply.
2 Do not place this unit close to strong
 magneticeld.
3 If the system is brought directly from a cold
to a warm location, or is placed in a very
damp room, moisture may condense on the
lens inside the player. Should this occur, the
system will not operate properly. Leave the
system turned on for about an hour until the
moisture evaporates.
4 Should any solid object or liquid fall into the
system, unplug the system and have it
 checkedbyqualiedpersonnelbefore
operating it any further.
5 Do not attempt to clean the unit with
chemical solvents as this might damage the
 nish.Useaclean,dryorslightlydampcloth.
6 When removing the power plug from the wall
outlet, always pull directly on the plug, never
yank on the cord.
Important Safety Instructions
4
www.tibo-electronics.com