Tibo PP100 - Troubleshooting; No Power Solutions; Remote Control Issues; Unit Not Responding

9
 indicatorashesbutnotturnred,
code received is not successfully.
5 Repeat steps 3-4 to program more
buttons on the smart remote
control (A).
6 Press LEARN to save the learning
and then to exit the learning mode.
Troubleshooting
To keep the warranty valid, never try
to repair the system yourself. If you
encounter problems when using this
unit, check the following points before
requesting service.
No power
- Ensure that the AC cord of the
apparatus is connected properly.
- Ensure that there is power at the
AC outlet.
- Press standby button to turn the
unit on.
Remote control does not work
- Before you press any function
 button,rstselectthecorrect
source.
- Reduce the distance between the
remote control and the unit.
- Insert the battery with its polarities
(+/-) aligned as indicated.
- Replace the battery.
- Aim the remote control directly at
the ensor on the front of the unit.
No Response From the Unit
- Disconnect and reconnect the AC
power plug, then turn on the unit
again.
Specications
General
Power Requirements ..AC 230V ~ 50Hz
Power Consumption .................... 6.5W
Output Power .............. 7.5W x 2 + 15W
Total Harmonic Distortion .....................
.......................................... 1%(1kHz, 1W)
Audio Input Sensitivity/Impedance
LINE: .................................500mV/47kΩ
Frequency Response ............................
..........................40Hz - 20kHz(+0 / -3dB)
Unit Dimensions (W x H x D) ..................
...................................584 x 50 x 218mm
Speaker
Front
Impedance ...................................... 3Ω
Rate Power .................................... 10W
Woofer
Impedance ...................................... 6Ω
Rate Power .................................... 30W
Remote
Distance ............................................6m
Angle ................................................ 30
O
9