SDR-OMNI Avionics Test Set User Manual
Revision B 6 June 2023 Page 5
CHAPTER 1 INTRODUCTION
1.1 SCOPE
This manual is intended to familiarize the user with the operating procedures necessary to properly use the SDR-
OMNI Avionics Test Set.
1.2 FEATURES
The SDR-OMNI is a lightweight, software-defined radio frequency (RF) test set for testing RF avionics in the 200
kilohertz (kHz) to 1.6 gigahertz (GHz) range. The SDR-OMNI is designed to test all basic navigation and
communications avionics functions common to modern civil and commercial aircraft, with provisions for certain
military avionics test requirements.
It uses software defined signal processing to test complex avionics navigations and communication signals.
The SDR-OMNI can be powered by either battery or AC adapter. The SDR-OMNI includes a lithium-ion (Li-Ion)
battery that lasts 6 hours with continuous operation or 24 hours on a 20% duty cycle. The SDR-OMNI also
includes an AC adapter (100-240 Volts AC (VAC), 47-63 hertz (Hz)) that can power the device and charge the
battery.
1.3 COMPLIANCE
This Product Meets or Exceeds the essential requirements of applicable European Directives as follows:
• EN 55022, B
• EN 61000-4-2, L2&3, B
• EN 61000-4-4, L2&3, B
• EN 61000-3-2, A
• EN 61000-4-3, L3, A
• EN 61000-4-6, L3, A
To Next Page
Loading...