42
ⓒ 2019. this is engineering Inc. All Rights Reserved.
2. While the drone is hovering, press and hold the jog button as shown in the figure
to switch to flight mode. Ring control is enabled after the controller vibrates once.
When switching to flight mode using the jog button, the center of the ring on your thumb should be within 1 cm
(0.4 in) around and above the center of the controller pad. If the ring is out of the range, the controller gives off a
warning and fails in switching to flight mode.
When switching to flight mode, exercise caution in moving the ring as accidents may occur from sudden movement
of the drone.
1cm
To Next Page
Loading...
