Why my TierTime 3D Printers cannot detect the printer?
If your TierTime 3D Printer is not being detected, ensure the printer driver is correctly installed. Also, check the USB cable for any defects. If the issue persists, try restarting both the printer and your computer.
What to do if my TierTime 3D Printer cannot extrude plastic?
If your TierTime 3D printer isn't extruding plastic, here's what you can do: First, withdraw the filament, cut off the melted tip, and reload it. If that doesn't work, the nozzle might be clogged, so try replacing it or removing the clog. Also, ensure you're using the recommended UP Fila filament, as thicker filaments can cause issues. Finally, if you're using PLA, consider switching to ABS, as PLA can sometimes cause extrusion problems.
General| Build volume | 255 x 205 x 205 mm |
|---|---|
| Filament diameter | 1.75 mm |
| Connectivity | USB |
| Closed chamber | Yes |
| Nozzle Diameter | 0.4 mm |
| Technology | Fused Filament Fabrication (FFF) |
| Supported materials | ABS, PLA, TPU |
| Power Requirements | 110-240V, 50-60Hz |
| Weight | 20 kg |
| Layer resolution | 0.1 to 0.4 mm |
To Next Page
