Why my TierTime 3D Printers cannot detect the printer?
If your TierTime 3D Printer is not being detected, ensure the printer driver is correctly installed. Also, check the USB cable for any defects. If the issue persists, try restarting both the printer and your computer.
What to do if my TierTime 3D Printer cannot extrude plastic?
If your TierTime 3D printer isn't extruding plastic, here's what you can do: First, withdraw the filament, cut off the melted tip, and reload it. If that doesn't work, the nozzle might be clogged, so try replacing it or removing the clog. Also, ensure you're using the recommended UP Fila filament, as thicker filaments can cause issues. Finally, if you're using PLA, consider switching to ABS, as PLA can sometimes cause extrusion problems.
General| Build volume | 255 x 205 x 205 mm |
|---|---|
| Filament diameter | 1.75 mm |
| Connectivity | USB |
| Closed chamber | Yes |
| Nozzle Diameter | 0.4 mm |
| Technology | Fused Filament Fabrication (FFF) |
| Supported materials | ABS, PLA, TPU |
| Power Requirements | 110-240V, 50-60Hz |
| Weight | 20 kg |
| Layer resolution | 0.1 to 0.4 mm |
General safety guidelines for operating the UP BOX 3D printer, including temperature, moving parts, and environmental conditions.
Steps to download and install the UP! software, including driver installation.
Procedure to verify successful printer driver installation by checking software options and LED status.
Explanation of the initialization process, its importance, and the two methods to perform it.
Steps to initiate automatic platform leveling using the software's 'Auto Level' function.
Procedure to detect and set the nozzle height using the software's 'Nozzle Height Detect' function.
Detailed steps for manually leveling the print platform using screws and paper for measurement.
Step-by-step guide covering printer connection, software selection, and filament loading for printing.
Explanation of the print preview window, its options, and how to send the model data to the printer.
Method to re-calibrate the printer for accurate dimensions by printing and measuring a calibration model.
Advice on nozzle height, platform calibration, pre-heating, airflow, raft usage, and support settings for better prints.
Table listing common printing issues like temperature errors, extrusion problems, and connectivity, with their solutions.
Step-by-step protocol for manually setting the nozzle height, including initializing the printer and placing paper.
Procedure for setting compensation values to adjust for platform variations after setting nozzle height.
To Next Page
