What to do if my TierTime 3D Printer cannot be detected?
If your TierTime 3D Printer cannot be detected, first ensure the printer driver is correctly installed. Then, check for a defective USB cable. Finally, try restarting both the printer and your computer.
Why my TierTime 3D Printers cannot extrude plastic?
Your TierTime 3D Printer might not be extruding plastic due to several reasons. The nozzle may be clogged with plastic, in which case you should replace the nozzle or remove the clog. Alternatively, the filament might be too thick, so ensure you are using UP filament. You can also try switching to ABS.
Attaching the spool holder to the back of the printer for filament management.
Loading the filament spool and guiding it through the tube into the printer.
Adjusting the platform height to touch the nozzle for accurate first layer.
Setting compensation values for different points to ensure consistent print height.
Resizing the loaded 3D model by a specified scaling factor.
Instructions on how to safely remove and clean a clogged or dirty nozzle.
General| Build Volume | 120 x 120 x 120 mm |
|---|---|
| Nozzle Diameter | 0.4 mm |
| Filament Diameter | 1.75 mm |
| Printing Technology | Fused Filament Fabrication (FFF) |
| Operating Software | UP Studio |
| Compatible Filaments | PLA, ABS |
| Connectivity | USB |
To Next Page
